防静电无尘产品制造商 | 天瑞静电科技
中文版        
 
News
新闻分类
详细信息
What should we notice when installing ESD rubber mat?

ESD rubber mat is made of antistatic materials, static dissipative materials and synthetic rubber made by a variety of processes.Normally, it is two layers, surface layer which is a little thin (about 1/4 of the total thickness) is dissipative layer, bottom layer is conductive layer(about 3/4 of the total thickness.Surface(Matt and gloss) color of this ESD rubber mat is green,blue,gray,while bottom color is black.Resistivity of the surface is 10^6-10^9Ω,and it is 10^3-10^5Ω on the bottom.

Please be sure to notice following when you installing ESD rubber mat:
1.Basis of the ground floor for the mill, ceramic floors, wood floor.
2.Ground to be flat, no significant irregularities, roughness less than two thousandths.
3.Ground should have enough strength and no sand, shelling phenomenon.
4.Ground to be dried.
5.Using 120# gasoline or xylene impurities cleaning the ground
6.Laying on the ground copper bar or aluminum, such as copper strip having a thickness of 0.02mm, width of 30mm, the number of floor coverings according to the actual requirements to determine the length and number, with the laying of the copper bar to the end toward the ground.
7.After laying the ground guide grid, clean and dry ground, painted conductive glue to dry for 20-30 minutes, until the stick in hand, anti-static bottom surface (black face) the same as (coated conductive adhesive once), and then antistatic adhesive sheet and ground, and then re-roll rolling 5 times, so that the surface of the anti-static sheet can be neatly straight, after 48 hours at room temperature can be used.
8.Ambient temperature requirements during the construction of not less than 25 degrees Celsius and humidity and good ventilation is not greater than
9.Conductive glue resistivity less than 108Ω, peel strength Kg/2.5cm
10.Gap between the conductive coating conductive glue can be used, can also be pasted on the surface of the copper strip.


本文共分 1